AYN Thor "PRO" Docking Station for UGREEN 6-in-1

AYN Thor "PRO" Mount for UGREEN 6-in-1 USB-C Dock (Custom Fit Console-Style Stand)

Turn your UGREEN 6-in-1 Dock into a specially designed docking mount for the AYN Thor PRO with this 3D printed attachment mount. It locks the dock into position and provides a front cradle for the Thor, creating a compact console hub capable of 100W PD, 4K @60Hz or 2K @120Hz ready.

• gives the system a clean appearance

• avoids the screen being fully open when you don’t need it

• keeps the screen protected during external monitor use

Optimized Airflow for Safe Operation

This mount is designed with the Thor’s ventilation in mind, keeping all air vents unobstructed for continuous airflow. By elevating and cradling the console, heat is efficiently dissipated from the back of the unit, preventing overheating during extended gaming sessions. You get a stable docked setup without compromising the system’s cooling performance.

Required Hardware:

• UGREEN Steam Deck Dock 6-in-1 Amazon.com: UGREEN Steam Deck Dock 6-in-1 4K@120Hz HDMI 2.1, 100W PD, USB-A & USB C 3.0, Gigabit Ethernet, Dock for Rog Xbox Ally 2025, Steam Deck, ROG Ally, Region Go, MacBook : Electronics

• Right Angle USB C Cable 1ft Amazon.com: Right Angle USB C Cable 1ft, 12 inch 240W Short USBC to USBC 3.2 Gen 2X2 20Gbps Data Cable 4K Video Monitor Cord, PD 3.1 Type C Charging Cord for iPhone 16 17 Pro Max, MacBook, iPad, Galaxy S25 : Electronics

Printer size needed: 220 × 220 × 250 or larger.
Fits smaller beds when rotated diagonally.

Materials:
PLA works well for everyday use
PETG/PETG-CF recommended for higher heat
ABS or ASA for maximum strength

Settings:
Layer height 0.16–0.2 mm
Two or three perimeters
Print the part with at least 15% infill  Note: You can print with 0% infill if using 3 perimeters
Supports are needed in three locations
Estimated print time: 6–9 hours

Assembly and Installation:

1.Start by raising the Ugreens back support up into the supporting position.                                                  2.Simply place the attachment mount onto the Ugreen Dock until the base is fully seated between the             rubber base pads, sliding the back locking hook over the top edge of the Ugreen back support (Its a tight       fit as should be).                                                                                                                                                    3.Route the USB-C pigtail through the base channel and around to the rear connection port.                4.Place the AYN Thor into the dock after connecting the USB-C and enjoy playing on the big screen.

Recommended Foam Tape:

Thin foam tape (1/2″ × 1/16″) is recommended for protective padding.
Provides a secure, professional fit and protects the Thor from scratches. Yotache Thin Foam Tape Weather Stripping (.50) 1/2 Inch Wide x 1/16 Inch Thick (New Adhesive Craft), Seal Gasket for Speaker, Door Insulation, Soundproofing, Rattle, 33 Ft Length - Amazon.com

How to Use the Foam Tape:

Cut strips to match the indented areas.
Peel the backing and apply carefully, keeping the strips straight and even.