Curved truss bridge Remix for Hotwheels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A curved truss bridge for hotwheels cars.
- Ocena
- 0 / 5
- Polubienia
- 125
- Pobrania
- 376
- Wydruki
- 0
- Wyświetlenia
- 2216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a scaled up “Curved truss bridge for HO trains” to be large enough for two lane hotwheels cars to drive through. Scaling this up made it nearly 300mm long so i split the model and added two small connector slots in the middle. The same connector slots are used for entry and exit and i've included two connectors, the smaller of which connects the middle portion together and the longer can be used to get a nice fit on some howheels track.
You can print the halves standing up (printing flat will likely need supports.) If your connectors fit too tight you can shrink them on just their shorter (maybe X?) axis. Or you can try and adjust your xy compensation but they are modeled to be nearly exact with a very minimal tolerance.