Obi-Wan Kenobi Drumsaber

This is a lightsaber designed to go on the bottom of your drumstick, to turn the stick into a blade.

For this drumsaber, if you have PLA gloop, coat the thin part of the saber (Especially where the collars meet the rod) to give additional strength, When using for dueling, it is highly recommended to grab the saber by the collar, where the drumstick is in the print, because while it does look cool it can break easily if you don't treat it with care as you can see on my model.

PAY ATTENTION TO THIS* --> This model will download sized for a 2a (16mm diameter) drumstick.This is the thickest size, so once it is loaded in the slicer, scale it to these percentages depending on your A rating:

5a- 90%

7a- 93.75%

2B- 100% 

These measurements also apply to the test print, in case you were wandering.

I recommend using Overature LW PREFOAMED PLA for this, but any filament will work. (Overature has the best weight to durability ration THAT I'VE TESTED)

Print speed is optional, since the filament is already foamed, speed didn't effect the print quality for me.

Print temperature should be as usual for most PLA's at 195-210 degrees C

TREE SUPPORTS RECCOMENDED

For a good strength to durability ratio, I recommend anywhere between 15% to 25% infill

Lastly, I don't know how many people pay attention to what glue they use, as long as it sticks, but PLA gloop, Gorilla Glue (any type) or a 3D pen for welding is highly recommended for not just this print, but any future prints of yours. Super glue does not stick well to Overature filaments well for some reason.

Feel free to print and sell these in your workplace or school! And spread the word on where to find these because I will be uploading more hilts!