DIY Weather Station Radiation Shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Radiation Shield for DIY Weather Station
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 430
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
This enclosure is designed for mounting environmental/weather sensors (e.g., Temperature, Humidity, and Air Pressure sensors) and accommodates a 3 x 7cm PCB for an auxiliary electronic module.
The sensor mounting features are specifically designed for common AliExpress modules, such as the AHT20 + BMP280 combination.
Difficulty Level: Advanced
Brass hot melt inserts require careful and precise installation.
The current balustrade mounting may need to be redesigned to suit your needs.
Sensor monting may require redesign
Preferred Printing Settings
Material: PET-G (tested)
Infill: 30% rectilinear
Perimeters: 3 (1.2mm)
Layer height: 0.1mm
Solid layers: 12 (1.2mm)
Supports: not required
Nozzle diameter: 0.4mm
Additional Components Required
Three M4, 250mm Stainless Steel Full Threaded Rod
Three M4 Stainless Steel Flat Washers
Three M4 stainless steel nuts
Ten M4 x 4 x 6mm Brass hot melt inserts
Three Round Head, M4 x 20mm screws
Four Round Head, M4 x 65mm screws (for reference design of Balustrade mounting)
Screws, washers and nuts for mounting the sensor
Environmental/weather sensors
3x7cm Weather station electronic module (e.g. ESP32-C3 SuperMini, I2C protection circuit, Mini560 PRO 5A DC-DC Step-Down Stabilized Voltage Supply Module)
Additional Tools
Heat-Set Insert Installation Tool
Warnings!
Do not use countersunk screws! Use only screws with a flat bearing surface (or flat underside)!