Performance intake manifold for Fiat 850 engines in a Fiat 600-based car
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The engines in the Fiat 850 family of cars were slightly canted. In order to keep the carburetor level, they canted…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
12/19/25 update to release V2 based on feedback from an owner of the JO/EL intake:
-Changed the cutouts under the venturis from spherical to conical.
-Changed engine side venturi cutout diameter from 36mm to 37mm.
-Changed non-engine side venture cutout from 8mm deep to 10mm deep.
The engines in the Fiat 850 family of cars were slightly canted. In order to keep the carburetor level, they canted the intake manifold in the opposite direction. The engines in the Fiat 600s were level. Swapping an engine from a Fiat 850 into a Fiat 600 is a popular upgrade, but because of the canted Fiat 850 intake manifold, this means that the carburetor will be tilted. There has been no solution to this problem until now.
I have created a performance Fiat 850 intake manifold for various Weber carburetors for use in a Fiat 600-based car. I took design inspiration from the Alquati and Cabeza de Vaca - hopefully taken the best from both. First, I have taken the cant out of the manifold so that it is now level. The outlet has been slightly enlarged roughly 2mm in all directions where it meets the cylinder head (based on the Alquati manifold). The carb mount is slightly swept back to match John Edward's Cabeza de Vaca intake design. Same with how the plenum narrows down below the venturis.
The mounting flanges are roughly 11mm, the plenum wall is 5mm and it is 79mm tall. The carb mounting holes are 46mm x 93mm and the venturi holes are 36mm - good for the Weber 32/36DVG or the 36DCD, etc. You will need to tap the four holes on top to insert studs or drill them out for bolts.
Print with support enabled. Print this out in plastic and, if you like the result, have it printed in aluminum and install it on your car! Here is the link to PCBWay for metal printing.