1 / 4
AMD BC-250 120mm Fan Top Cover — zdjęcie 1
1 / 4

AMD BC-250 120mm Fan Top Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the top case with dual 120mm fans for the Asrock BC-250 model.

Ocena
0 / 5
Polubienia
4
Pobrania
114
Wydruki
0
Wyświetlenia
2718
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

This is a top case for the Asrock BC-250 model equipped with dual 120mm fans.

Most models use blower fans or are very large cases.

Therefore, we created a case that can mount dual 120mm fans on top.

Before use, you must pre-drill the heat sink using the “bc-250 scoop”.

After securing it to the rear PCI slot, remove the opposite metal handle section and mount it using the remaining two screws.

We strongly recommend using support brackets. (Some are pre-machined, but using these will yield a cleaner result.)

The protruding connection points at the joints require light finishing with a knife or sandpaper.

Securing them with adhesive after assembly allows for more stable use.

(As this is my first attempt at 3D modeling, the lines visible on the model will not appear on the actual printed part.

Modeled in Tinkercad. Suggestions for improvement are always welcome.)

Please bear with any shortcomings as this is my first modeling attempt.

Printer used: Bambu P1S + PETG / Due to bed size limitations, it is split into 2 parts.

Tagi