Airbrush and compressor mounting for IKEA Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Set of prints for mounting an Airbrush and small compressor to IKEA Skadis
- Ocena
- 4,9 / 5
- Polubienia
- 84
- Pobrania
- 451
- Wydruki
- 10
- Wyświetlenia
- 2333
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I recently bought one of these small compressors to have a soft introduction to airbrushing, and drew up some mounts for them for IKEA Skadis.
There are three parts:
Cable Spool
Small spool for the air hose. Prints without supports, and I've printed it in PLA with 0.2mm layers.
Airbrush holder
Should fit most airbrushes. Prints without supports, and I've printed it in PLA with 0.2mm layers.
Compressor shelf
Consists of the shelf itself and an upper support to hold it in place. The shelf has an opening for the air hose connector. I don't know if these compressors come in a lot of different shapes or sizes so YMMV. Mine has model number TM-80S.
The print requires support for the hooks on both the shelf and the support.