Casio F-91W Watch Bar Mount

Casio F-91W Watch Bar Mount – Fits 22.5 mm Handlebars

Mount your trusty Casio F-91W exactly where you need it. This simple, sturdy bar mount holds a Casio F-91W watch securely on any 22.5 mm bar — perfect for bike handlebars, a desk frame, a tripod arm, or anywhere you want the time (and that god-tier watch) glanceable and out of your pocket.

Attachment is clean and tool-free: internal cable-tie channels run through the body so you can strap it down tight with no clamps, screws, or adhesive. The channels accept cable ties up to 3.6 mm wide.

This is a remix of BjörnR's Handlebar 35 mm Casio F91W mount — the watch-retaining top has been kept, while the base has been fully redesigned to fit a 22.5 mm bar with added cable-tie channels for a rock-solid hold.

✅ Features

• Holds a Casio F-91W securely on a 22.5 mm bar

• Internal cable-tie channels for a clamp-free, tool-free fit (accepts ties up to 3.6 mm wide)

• No supports required — prints cleanly as-is

• Compact, low-profile design

• Ideal for handlebars, frames, and round tube mounting

🖨 Recommended Print Settings

💡 ASA was used for long-term durability and UV/weather resistance, which makes sense for an outdoor or bike-mounted part. PETG is a perfectly good alternative for indoor use.

🔧 Installation

1. Print the mount — no supports needed.

2. Seat the Casio F-91W into the top retaining section. Use the factory pins.

3. Position the mount on your bar of choice.

4. Feed cable ties (up to 3.6 mm wide) through the internal channels, pull tight and cut excess.

🔩 Compatibility

• Watch: Casio F-91W

• Bar diameter: 22.5 mm (e.g. bike handlebars, round tube/frame)

• Cable ties: up to 3.6 mm wide

If you print one, I'd love to see where you mounted it — post a make!