Kampfer Head Base for HGUC Kampfer

Print Instructions:

Printed with both PLA & PETG

• Printed at 200C w/ PLA

• Printed at 230C w/ PETG

Settings:

• 0.2 mm layer height

• 0.4 mm line width

• Supports enabled - Used tree supports 

• Infill: Doesn’t matter; The model is too thin for any infill

• Orientation: The model should be printed upside-down, i.e., the top of the central tube should be touching the print bed. While the model may be able to be printed right-side up, I don’t trust the entirety of the model to be held up by tree supports

Assembly Instructions:

What’s necessary:

• The 3D printed part “Kampfer_Head_Base”

• Polycap 9; There should be an extra one which isn’t used by the kit - This will be the moveable piece

• Some 2.5mm wide runner, about ~5mm long - Will be used for the camera portion of the eye. 

  • I used a pink runner for this

• Headpiece B2; Needs modification for the polycap to fit inside the finished head assembly

Polycap

One of the pegs will need to be cut down flush. Images below show what needs to be removed, and what it should look like after.

Before:

After:

Headpiece B2

Some plastic inside of headpiece B2 needs to be removed. Remove enough for the flush side of polycap 9 to fit under the headpiece when the head is assembled. Below is an image of what needs to be removed, and what it should look like after:

Before:

After:

Camera

Insert the cut runner into the polycap. Leave a little sticking out to add depth to the camera. I added some red tape around mine for a tighter fit & aesthetics.

Full Assembly

Insert the remaining polycap peg into the front-most hole of the printed part. It should look like this:

Finish building it as the manual instructs (Step 6). This completed assembly should be the stand-in for the piece A6. 

Once completed, the polycap can be rotated left & right to give the effect of the moving mono-eye.

Additional Notes

Feel free to adjust/remix this model if necessary, but please give proper attribution. Not for commercial use.