1 / 6
High performance intake manifold for Fiat 850 engines in a Fiat 600-based car — zdjęcie 1
1 / 6

High performance intake manifold for Fiat 850 engines in a Fiat 600-based car

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A high performance Fiat 850 intake manifold for various Weber carburetors for use in a Fiat 600-based car.

Ocena
0 / 5
Polubienia
0
Pobrania
11
Wydruki
0
Wyświetlenia
94
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

12/19/25 update to release V2 based on feedback from an owner of the JO/EL intake:
-Changed the cutouts under the venturis from spherical to conical.
-Changed engine side venturi cutout diameter from 36mm to 37mm.
-Changed non-engine side venture cutout from 8mm deep to 10mm deep.

The engines in the Fiat 850 family of cars were slightly canted. In order to keep the carburetor level, they canted the intake manifold in the opposite direction. The engines in the Fiat 600s were level. Swapping an engine from a Fiat 850 into a Fiat 600 is a popular upgrade, but because of the canted Fiat 850 intake manifold, this means that the carburetor will be tilted. There has been no solution to this problem until now.

I have created a high performance Fiat 850 intake manifold for various Weber carburetors for use in a Fiat 600-based car. I took design inspiration from John Edward's JO/EL Cabeza de Vaca intake. The top is similar to my other intakes, which all come from JO/EL. The outlet is much wider than the Alquati and it is focused directly over the intake runners in the cylinder head (see picture). This supposedly allowed much better air/fuel flow to cylinders 1 and 4.

For more information on the JO/EL intake, please see this PDF. It's an excerpt from John's book, "The Fiat 850 Racers Handbook" from 2014.

The mounting flanges are roughly 11mm, the plenum wall is 5mm and it is 79mm tall. The carb mounting holes are 46mm x 93mm and the venturi holes are 36mm - good for the Weber 32/36DVG or the 36DCD, etc. You will need to tap the four holes on top to insert studs or drill them out for bolts.

Print with support enabled. Print this out in plastic and, if you like the result, have it printed in aluminum and install it on your car!  Here is the link to PCBWay for metal printing.

Bear in mind that you will need to do quite a bit of intake porting on your cylinder head. I make no performance or any other guarantees. But I'm going to try it!

Tagi