CR10 Bed Cable Strain Relief JST Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This replaces the stock cable strain relief part on Ender 3D printers to adapt to a 24v build plate with JST connector.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This replaces the stock cable strain relief part on Ender 3D printers to adapt to the alternate 24v build plate with a JST connector (see attached images). Specifically, on the CR10, but it would probably work for others.
The original strain relief connector from the 12v bed does not work with the new JST connector style so here's a redesign.
No supports needed. I printed in PLA and there aren't any warping issues (yet) from it being near the heated build plate. There's room for either one big ziptie or two small ones!
I've added a slightly different "base" thickness a new part with the extension "Silicone" added to the filename to work correctly with Silicone Bed Mounts. This model works with the set of silicone bed mounts that measure with the short mount difference of 2mm shorter than the bigger mounts. In my case, my tall mounts measured at 18mm and the short one measured at 16mm.
Hopefully this works for you! Take some strain off your printer!
Edit: Added .step files.