High performance intake manifold for the Fiat 850 family of cars.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A high performance intake manifold for the Fiat 850 family of cars.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 300
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
12/19/25 update to release V2 based on feedback from an owner of the JO/EL intake:
-Changed the cutouts under the venturis from spherical to conical.
-Changed engine side venturi cutout diameter from 36mm to 37mm.
-Changed non-engine side venture cutout from 8mm deep to 10mm deep.
I have created a high performance Fiat 850 intake manifold for various Weber carburetors for use in a Fiat 850-based car. I took design inspiration from John Edward's JO/EL Cabeza de Vaca intake. The top is similar to my other intakes, which all come from JO/EL. The outlet is much wider than the Alquati and it is focused directly over the intake runners in the cylinder head (see picture). This supposedly allowed much better air/fuel flow to cylinders 1 and 4.
For more information on the JO/EL intake, please see this PDF. It's an excerpt from John's book, "The Fiat 850 Racers Handbook" from 2014.
The mounting flanges are roughly 11mm, the plenum wall is 5mm and it is 79mm tall. The carb mounting holes are 46mm x 93mm and the venturi holes are 36mm - good for the Weber 32/36DVG or the 36DCD, etc. You will need to tap the four holes on top to insert studs or drill them out for bolts.
Print with support enabled. Print this out in plastic and, if you like the result, have it printed in aluminum and install it on your car! Here is the link to PCBWay for metal printing.
Bear in mind that you will need to do quite a bit of intake porting on your cylinder head. I make no performance or any other guarantees.