Unifi Protect G6 Pro Turret wall mount with cable storage compartment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rugged outdoor wall mount for a Unifi G6 Pro Turret camera. Provides ample space for an Ethernet cable service loop.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 528
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Original onShape project is at https://cad.onshape.com/documents/df32f8a65ca0d19ae598f9de/w/227b16ae0ab004c1ca0510aa/e/ffd23202c4a9013b80f16dd0?renderMode=0&uiState=694406e2fa4432575b557fbf
This wall mount is intended to provide a more rugged wall mounting solution (closely spaced M4 bolts aren't very suitable for exterior masonry wall mounting), with lots of space to stow a meter of an Ethernet cable service loop.
Ubiquiti Unifi G6 Pro Turret PoE CCTV camera can be bolted to this wall mount using M4 nuts and bolts. The larger 3D printed mount can then be bolted into an exterior wall using M6 bolts with 18mm penny washers and some suitable masonry wall anchors.
The camera fits snugly into the mount. A gap is provided on the lip of the mount to allow access to the locking grub screw. A water drainage hole is provided underneath, which also doubles as a route to egress the ethernet cable if you are not routing the cable directly through the wall.
This should be printed in a UV and heat-resistant material. PLA, and especially black PLA, is wholly unsuitable for this outdoor application. I have printed this in white ASA with 100% infill for a very sturdy, functional print.