1 / 4
Outdoor - Solar System - small (14x7 cm) 3.7v 500mAH rechargeable battery setup — zdjęcie 1
1 / 4

Outdoor - Solar System - small (14x7 cm) 3.7v 500mAH rechargeable battery setup

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Solar system electronics and enclosure setup for small (3.7v 500mAH) outdoor electronics projects

Ocena
0 / 5
Polubienia
2
Pobrania
5
Wydruki
1
Wyświetlenia
72
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This small solar system setup allows for the recharging of a 3.7V 500mAH lithium battery.  During the day the LDR (photoresistor) has low resistance, pulling the transistor base low—keeping it off.  In darkness, the LDR’s resistance increases, raising the base voltage—turning the transistor on and allowing energy to flow to the external components (eg. LEDs).

Materials Required

Printing Tips

  • Multifilament Printer - requires PETG/PLA (enclosure & Spike) and TPU (gasket) with 2 parts (solar panel holder and electronics holder that can be printed at the same time.  The gasket is associated with the electronics holder part and prints in place.  Recommend printing with 3 perimeters, 0.15mm layer height and 5% infill with supports

  • Monofilament printer - requires PETG/PLA and recommend printing with 3 perimeters, 0.15mm layer height and 5% infill with snug supports.  The gasket item (part of the electronics holder fits into the groove of the solar panel but will not be flexible and therefore not a good seal.

Assembly

  • Electronics

    • Solar Panel

      • Prep the solar panel by add some additional wiring (10-15cm) to the + and - connectors

    • Electronics Package

      • Electrical Wiring Diagram

      • Soldered PCB board with battery underneath placed into holder.  Wires at the base of the diagram hookup to the exiting connector wire.  The LDR (photoresistor) middle left is connected to the wires on the left side of the PCB board.  Wires at the top of the PCB board go to the solar panel.

  • Enclosure

    • Spike

      • Place the large hex nut through the electronics holder enclosure then through the spike and secure with the respective nut at the angle you need it to be oriented.

    • Solar Panel Holder

      • Lay down a bead of silicon sealer glue on the inside rim of the solar holder and press into place the solar panel.  This should create a seal to prevent water getting into the enclosure and also hold the solar panel in place.

    • Electronics Holder Part

      • Place the photo resistor into the photo-resistor hole from the outside and spread the two wires to each side of the inside of the holder.  The add some clear sealer on the outside to secure and seal the resistor to the holder.

      • Place the electronics package into the holder slot with the battery underneath

      • Once all electronics are connected to the solar panel you can now secure the solar panel holder to the enclosure using the 4 x 8mm 4M hex nuts

      • For the connector lead exiting the enclosure use the silicon sealant to fill any gaps around the wire.

Associated Projects

Change Log

  • December 2025 - initial draft

Tagi