Endcaps for 142x12mm thru axle on Wahoo Kickr v3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Converts the old and obsolete Kickr v3 to run 142x12mm thru-axle.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 305
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount a bike with a 142x12mm thru axle (most modern road frames, older non-Boost MTBs, etc) on the old Wahoo Kickr v3 (2017)
Is it strong enough?
I wouldn't print this in PLA no matter how solid you make it, and don't think PETG would be up to the task either. I printed in Prusament polycarbonate with carbon fiber since this is going to be mostly in compression - the trainer itself handles the twisting forces. Ultimately, it's up to you to decide if you feel confident running these, but I can say that I've been running endcaps printed in Prusament polycarbonate in a very similar setup in Hope Pro II hubs on my town bike for years now with good results.
Your mileage may vary and you accept all risk here, but in this case at least the worst that happens is you fall off your trainer. Embarrassing for sure but shouldn't be too risky.
Print instructions
I printed in Prusament polycarbonate as it is stronger and harder than normal filaments, and the carbon fiber infill should help with strength in compression, which is most of what these will see. I upped the shell count to 5 which made the key parts solid and printed at 0.2mm layer height with a 0.4mm nozzle. Prints without supports as oriented
Installation
Remove existing endcaps. Non drive side pushes in with the angled side facing outboard. Drive side threads on (reference; it's an M16x1.0 thread) and should only be hand tightened. The 17mm wrench flats are only there to assist with removal. This would also be a good time to pull and clean the freehub mechanism and apply fresh grease.
Backstory
I bought a used Wahoo Kickr v3 and wanted to mount a newer bike with a thru axle on it, but realized I didn't have the endcaps to make that happen. Contacted the friend and he didn't have them, so I went to Wahoo and discovered you can get a kit for the v4 and up and saw mention of thru-axles on the v1 and v2, but there was a gap right where I needed. Contacted Wahoo and they said that the kit was out of stock and they didn't know when it would be coming back since it's an obsolete trainer, so here we are.
I took measurements from the existing hardware (and printed [a holder](https://www.printables.com/model/1520453-quick-release-endcap-holder-for-wahoo-kickr-v3) for that once it was removed to keep it all together) as well as reference measurements from a 142x12 hub, then put these together. Printed up and installed, it comes out to 142mm, so there is that.
Unfortunately I also discovered that the bike I was going to mount - an older Trek Checkpoint ALR - wouldn't mount due to the "Stranglehold" adjustable dropouts. The adjusting nuts sticking out of the back of the frame interfered with the carrying handle. Other than that, it looked like everything would work, but I haven't actually tested it.