Adjusted/remixed bushing screw for 3D-Printed Yarn Winder model originally by BGDglider
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gear-mounting screw remix: smooth shank w/ larger OD near head to reduce drag and gear wobble; adds screwdriver slot
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 160
- Wydruki
- 6
- Wyświetlenia
- 414
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the gear-mounting bolt for the wonderful yarn winder model posted by BGDglider. The original model worked well for me with one exception: each screw that holds the drive and middle gears in place ("gear-screw-shorter-head.stl") had too small of an outer diameter where passing through the bushing of the model “wheel-spacer.stl”, creating unwanted “wiggle room” around the screw and allowing the gears to unmesh and slip under load.
This remix modifies the original gear-mounting screw ("gear-screw-shorter-head.stl") in three ways:
adds a smooth shank for the section of the bolt in contract with the bushing
uses a larger diameter in the smooth shank section to reduce lateral gear wobble (threads remain the same)
adds a screwdriver slot to make it a bit easier to tighten or remove the screw
All other parts of the original design are the same; see the original design by BGDglider for the model files.
The screw can be printed standing up with no supports if positioned so the head of the screw is flat on the build plate.
Suggested print settings:
infill:
50%layer height:
0.20mmavoid crossing perimeters:
truescarf joint placement:
Everywhereautomatic infill combination:
trueextra perimeters if needed:
truebottom fill pattern:
Archimedean chordsSpeed for non-print moves, travel:
75mm/s