UTEC Ultraloq U-Bolt Pro Rain Cover

I love my U-bolt Pro smart lock, but man I am super sick of the fingerprint sensor when it rains - it gets moist and then beeps all night because it registers the rain as a finger.  I've just designed & printed this after another frustrating night of beeping so have not fully op-tested yet, but it fits great and should keep out most moisture, especially if the lock is under an overhang (like on a covered porch).  Will update with additional info and/or a new design if this doesn't do the trick.  

Printing Instructions:

I printed mine in PETG at .2mm layer height, 20% infill, 4 wall loops.  No supports or brim required.   Print in a material appropriate to the weather and sun exposure in your location.

Installation:

Attach the lid to the base before installing with 2x M3x25mm button head screws.  The screws go directly into the plastic.  For the most part, install the smart lock as usual.  Mate the exterior lock face to the metal spacer (if using), then seat that assembly to the base of the rain cover tightly, hinge side oriented up, hold that to the outer side of the door, and then feed the cables through.  At this point, install the rest of the lock hardware as normal.  The base of the lock cover is not thick, and should not pose a problem when mounted between the lock and the door.