Satisfactory DNA Capsule Coasters & Dispenser

Introduction:

This is a Satisfactory-inspired coaster set stored inside a DNA capsule-style dispenser. The capsule holds the coasters inside and lets you easily pull them out when needed, making it both a functional desk accessory and a fun decorative piece for any fan.

The base model was taken as closely as possible from this set:
https://www.printables.com/model/1039870-satisfactory-all-parts

The whole capsule was then scaled around the coasters, so their size became the main reference dimension.

It is not a 100% accurate replica of the in-game model, because during the process it turned out that some details in the game are not actual geometry but only textures. So at some point I stopped chasing perfect accuracy.

FreeCAD file is attached.

Coasters

Everything here is pretty straightforward. The 3MF file already contains all parts pre-painted, so you just need to place the image piece into the base and secure it with a bit of glue.

If you choose to print the version with circular feet on the bottom, the feet should be printed in TPU. Unfortunately, coasters with feet gettingstuck to each other, so they don’t really work with the capsule dispenser idea, as you won’t be able to easily pull them out.

DNA Capsule

Parts:

• Main tube (for the best result, the supported version is recommended, as the model is quite tall and the top part tends to wobble a lot near the end of the print)

• Top and bottom caps

• Blue tube part (top and bottom versions are different)

• Tube detail (ring thing with bolt holes) ×2

• DNA layer (the pink part that goes between the walls)

• DNA shield (multicolor part) ×2

• Plug (to close the hole in the main tube after the DNA layer is installed)

• Clips

  • 12 regular for the top cap

  • 9 regular, 2 short, and 1 shortest for the bottom cap

The 3MF file contains all required parts in the correct quantities and pre-painted, including both main tubwill bewill bee variations.

Here are some assembly screenshots to show how everything fits together:

All parts are glued together, except the top cap. Do not glue it, as it needs to remain removable so you can access the inside and return the coasters.
If you choose to print the supported version of main tube, suports should be cut out before assembly.

If you tweak the slicing settings, make sure the outer walls of the supported main tube are set to 0.4 mm to avoid problems with the supports.