DAS FILAMENT - Gridfinity Swatches Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a generic gridfinity holder for “DAS FILAMENT” filament sample cards in two variations.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 98
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Just a generic gridfinity holder for “DAS FILAMENT” filament sample cards in two variations:
2x4x3 for a horizontal storage of the sample cards
1x4x4 for a vertical storage of the sample card
Both variations hold 33 cards in total, so two of them will hold all of the currently available ones (if you buy the version sold on their website).
The swatches have a size of 60x25x2mm, so it might fit other swatches with the same measurements (your mileage may vary).
The total height of the horizontal version is around 31mm, the total height of the vertical storage is around 65mm. Both fit conformably in an IKEA Alex drawer.
It is my first gridfinity design, so it is not optimized, but to save at least a little bit of filament I tested it successfully with:
0,2mm layer, 2 walls, 10% infill, gyroid
The gridfinity base has some basic 6,2 x 2,1mm magnet holes, in case you need them. There is NO lip to stack them on top of each other.
Any feedback is welcome.