Vacuum Robot Ramp / Door Ramp - flat bottom
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A ramp for the vacuum robot to get get over heigher door thresholds. The ramp contains dove-tail joints to connect…
- Ocena
- 5 / 5
- Polubienia
- 65
- Pobrania
- 740
- Wydruki
- 0
- Wyświetlenia
- 4767
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A ramp for the vacuum robot to get get over heigher door thresholds.
The ramp contains dove-tail joints to connect multibel ramps without screws.
You may want to use some velcro tape to the front side so you can attach the ramp safely to your step and it does not move when the robot runs over it.
The ramp dimensions are:
- width 20 cm
- height 1.8 cm
- depth 8 cm (min depth for my eufy robot)
Customize
For easier modification I added the step files and also the FreeCAD file.
In FreeCAD you can edit it very easily using the "Dimensions"-Spreadsheet.
To safe print time and filament use the following settings:
- Top Layers = 0
- Bottom Layers = 0
- Infill Density = 20%
- Infill Pattern = Triangels or Grid
With these settings my print time is 1:30h and uses 23g fillament
Print Settings
Printer: Ender 3 V2
Supports: No
Resolution: 0.36
Infill: 20% - Triangles or Grid
Filament: PLA
Build Plate Ahesion Type = None (or make the ramp smaller)
Top Layers = 0
Bottom Layers = 0
Category: Household