Hygger LED Aquarium Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for a 2ft wide aquarium.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 194
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Open Community License v1
The legs that came on the LED light caused it to have a weird wobble to it. Designed these to give it a more stable surface to rest on. It fit's with no side to side movement on a 2ft wide aquarium (tall 20 gallon).
BOM
M2x10 Self Tapping Screws
You can skip the screws if you want to not use the little feet that attach to the end of the brackets, or just glue them on. You can also get away with shorter screws if you want, anything over a 6mm length should hold on.
Print 1x BracketA, BracketB, 4x Leg. No supports are needed as they are built into the model, just snap the break away out from under the pegs.
I printed mine in ABS due to the heat from the LED but PETG will likely handle it without an issue.
BracketX_ScrewHoles should allow you to attach the end brackets through the end caps of the LED into the aluminum housing. Just take the existing screws out of the end caps, slide the bracket on, and screw in some longer self tapping screws. I didn't have any to test with, but I did test it without the end caps and it works just fine. I believe M2.5x16 would be long enough to reach.
Link to LED
https://amzn.to/44EhKb (Affiliate)