NCase M2 Curved Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
U shaped feet for NCase M2 to replace stubby, stock feet
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
U shaped feet for the stock foot locations on the NCase M2. These were inspired by https://www.printables.com/model/1246488-ncase-m2-feet but are my own clean sheet design that screws into the stock foot location but also allows you to mount the feet to the bottom without covering the screw holes that mount the bottom of the case to the front and back. There is also a cutout to fit two 13x13 rubber feet on each end so the case doesn't slip around.
Requires two M3x5x5 heat set inserts and I used four of the smaller ones from this set for the non-slip feet on each end. https://a.co/d/3MXrA9h