Sun Joe 24V-CRLM15 Mower Height Adjuster Arms
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replace the broken height adjustment arms on your Sun Joe 24V-CRLM15 24volt electric mower.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
Reverse engineered a replacement for a coworker's broken lawn mower. Seems that this part is unavailable from the manufacturer as a replacement and looks like it's only used on this one model.
The original part is PA6-GF, but I think that the issue with the original part is that they lightened up the inside to much for cost savings. The two that I have are both broken in places with the least amount of internal support.
Print settings:
Print this with PETG at bare minimum. I used ABS-GF for final print. PLA will not hold up
Is not compensated for material shrinkage, apply your own compensation if needed (likely won't be, it's not that critical)
Use plenty of walls and infill. I used 6 wall, 6 top/bottom, 50% infill.
Pictured and exported in the correct print orientation. This print direction very important for strength. Organic supports used for holes, but may not be necessary.
Changes on my design vs original:
- flattened the bottom for printing
- made holes slightly larger and ovaled out to help with print tolerances
- removed pointer needle, just pointed the end (again for printability)
- chamfers on edges where breaks happened to avoid having sharp corners, which promote breakage
- extra material in a couple places for strength
- not hollowed out