Mario Block Piggy Bank (Sealed)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Mario Block, 4" cube, that is designed to be printed in place and destroyed to open.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here is a compelling and technical description designed for platforms like Printables, Thingiverse, or MakerWorld.
📦 The "Unopenable" Mario Question Mark Block (Sealed + STEP File)
Is it a prop? Is there something rattling inside? The only way to find out is to break it open.
This is a fully sealed, print-in-place Mario Question Mark Block designed to be printed as a single, hollow unit with zero access to the interior. It is perfect as a frustration gift, a "smash-to-open" piggy bank, or a high-quality prop base for your own modifications.
🔧 Included Files
STEP File (.step): I have included the raw STEP file rather than just an STL. This allows you to easily import the geometry into CAD (Fusion 360, SolidWorks, Onshape) to modify the relief, change the wall thickness, or add internal mechanisms.
🖨 Critical Printing Instructions
⚠ READ BEFORE PRINTING ⚠
To ensure the block remains hollow and the top surfaces close correctly without internal supports, orientation is key.
Orientation: Rotate the block 45 degrees so it is balanced on a single edge/corner (diamond orientation).
Why? This turns the flat internal "ceiling" into angled walls, allowing your printer to bridge the gap without needing internal supports. If you print it flat, the inside will either fail or require supports that you can never remove.
Supports: Build Plate Only.
You will need a raft or brim and supports on the outside to hold the block upright on its edge.
Do NOT use "Everywhere" supports, or your slicer will fill the sealed void.
Infill: 10-15% (or 100% for the question mark relief details).
Layer Height: 0.2mm works great.
💡 Ideas for Use
The "Smash" Gift Box: Use the "Pause at Height" feature in your slicer to drop a coin, ring, or written note inside halfway through the print. Once finished, the object is trapped forever until the block is destroyed.
The Shaker: Drop a marble or failed print scrap inside during the print for a block that rattles but can't be opened.
Remix Base: Use the STEP file to cut a lid into the top or add a hinge mechanism.
Happy Printing! If you make a remix, please link it as a remix so I can see what you create!