10 inch rack mount ears for Seneca Element MP digital signage PC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for the Seneca Element MP PC to fit in a 10" rack. Front-back reversible.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 283
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
These rack mount ears are designed to fit the Seneca Element MP digital signage PC model with built-in power supply. They will fit in either direction without blocking intake or exhaust vents, and can be swapped so that the connectors can face outward or be hidden in the rack.
This mount is surprisingly sturdy when printed as oriented in the 3MF.
Printing
Print with 3-4 perimeters. Keep the orientation and supports in the 3MF for strength
Tested in PETG, but low creep material like ABS or ASA should also work well. I didn't have warping issues with PETG, but ABS, ASA, and others may need brim turned on or mouse ears added.
Assembly
Before installation check that the top, bottom, and sides are flush with the front and back plate. The Element MP is exactly 1U high, and if the top and bottom are not flush it will interfere with other rackmount gear. The easiest way to align the sides is to unscrew all the chassis screws slightly, then with the bottom resting on a flat surface carefully tighten them again.
Some of these come with a wall mount bracket that slides over studs on the sides. Unscrew these if necessary.
Use 4x M3x6mm pan head screws to mount. This is a tight fit in most racks and cap head screws may not fit. Do not use a screw longer than 6mm as anything longer can short the zesty parts of the power supply to ground.