Core One Rail System for MMU3 & Filamentalist V3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Core One top rail mounting system for MMU3 and Filamentalist V3 + Mini buffer
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 529
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a minimal, fully printed (apart from parts listed) solution for mounting the Filamentalist V3 rewinders to the Core One. Its simple to print and should require less than one 1kg of filament.
Includes a "mini multi buffer" unit to help with reliable extruder unloading to the MMU3. Personally I found this dramatically improved reliability with the Filamentalist rewinders, as the added resistance from the extended PTFE tubes and resistance from the rewinders can causes issues with filament unloads.
Y splitter for PTFE included to allow use of original Core One filament loading.
Notes:
Filamentalist reminders to be assembled in rear load orientation.
There is a small hole in the frame that the PTFE from the MMU3 can be pushed through from the MMU3 into the printer. It's a little tight, but no drilling is required.
Remember to set the new correct PTFE tube length in the printer settings for the modified PTFE length. Using a piece of filament is easiest.
Print settings I used:
Filament = ASA
Layer height = 0.2mm
Fill = 25% grid
Perimeters = 4
Solid layers top and bottem = 5
Supports are not required.
Print feet with TPU
Parts required:
22 x M3 10mm Counter sunk screws - For top joiners, filamentalist attachment, join front and back MMU support
36 x M3 10mm Socket cap head screws - For mounting MMU, bottom joiners.
6 x M3 6mm Socket cap head screws - For magets covers, MMU label plate
2 x 2x6x20 magnets (same as ones used for MMU plate holders)
Parts for Y splitter and buffer:
13 x Ptfe Ecas04 (same as ones used for filamentalist)
Printer Settings:
For reliable filament changes; change "Total Ramming Time" to 0.50 (s) in "Ramming Setting/Ramming Parameters". After changing this setting, you may need to increase the purge volume to 150 or more..