1 / 2
PrusaBox Enclosure 4 Way Relay Holder in Cover Lid Modified to be held with two screws
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modification to Collin Hill's design, for boards that might be slightly too wide for the two slots
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 773
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (35)Powiązane
This model is a variation of Collin Hill's lid design to hold a 4 way relay under the lid. When I printed his design, my board was just a bit too wide to fit in the slots, so I modified the design so that on the right side, the relay board is held by two screws. The left side is held in place by the original slot