Contact cover for the Canon PB-E2 motor drive booster grip for EOS-3 EOS-1n EOS-1v
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement contact cover for the Canon PB-E2 motor drive/battery pack.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
While reading the manual for the PB-E2 i realized it should have had a contact cover but mine doesn't. Since the 8xAA batteries add up to 12V 5A of electrical current, i figured i would make this cap to prevent it from shorting with anything in a backpack/bag.
How it works is you remove the small grip from your camera (GR-E1 or GR-E2), take the motor coupler cap off the bottom of the camera and put it in 3d printed cap, in the dedicated slot, remove the whole thing and put it on the small grip.
I printed it in TPU and would recommend you do the same.
PLA or PETG might require you scale the model to ~101% otherwise might be too tight.
I am not sure anyone uses the PB-E2 anymore, so if you're the one person that needed this please post a make or a comment :)
