1 / 10

Chain escape magic trick (Necklace through stick)

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magician is able to pull a chain through a wooden stick using this gimmick

Aktualizacja u źródła: 26 gru 2025

Informacje o modelu

CHAIN ESCAPE MAGIC TRICK

The magic trick and gimmick is shown here

This is the 3D model is slightly smaller than the original.

Requirements:

Magnet: D=15mm H=3mm (opening is 16x4.5mm)

Magnetic chain: Many hardware stores sell silver or gold-colored chains that are magnetic.

(Hornbach, Gamma and others in the Netherlands)

Wooden stick: A magic wand, pencil, pen, chopstick, bamboo... (not magnetic!)

Glue is optional

To print:

Material: PETG or PLA is fine.

1x Front Plate (printing WITHOUT SUPPORT The printer creates a nice bridge). One marker on the bottom.

1x rear plate. Two markers on the bottom.

1x Base using support (The base is deliberately quite high. The chain then hangs down nicely). Marker at the front.

1x Ring in order to hide the magnet opening (do not glue as it can leave marks)

Assembly:

Insert magnet and glue in place.

Press rings into the plates.

Press or glue the plates into the base so that the whole can be lifted onto the chain without any problems.

enjoy!

s10k