Xiaomi Vacuum Robot Dock Cable Storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cable storage for various Xiaomi vacuum robot docks. Easy to print.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Old Xiaomi / Mija robot vacuum docks came with a neat little cable storage at the back of the dock:
Unfortunately newer models do not feature any cable storage built-in, instead the charging brick is just plugged into the dock and the cable and the charging cable dangles off to one side, which is super anoying, especially when your plug is on the left instead of the right side of the dock.
This print replicates the old „back of dock“ cable storage and is simply slid ontop of the existing dock. The storage comes with two cable paths to either the right or left side of the dock. This allows neat cable storage as for the old docks.
Printing Instructions
Pick the right two model files (dock + lid) for your charger / dock type. Unfortunately not ever dock has the same measurements. I printed / tested the prints for a Xiaomi 3C Enhanced Edition Dock (Model No.: CDZC103) and a Xiaomi S40 Dock (Model No.: OV81-CDZ). The model numer is printed at the bottom of your dock. The same docks are re-used accross multiple vacuum robots, so you should just go by the model number.
Print with supports. Otherwise choice of materials is completely up to you. I printed mine with eSUN PLA-HS:
In case you own a different dock, feel free to write me a message. If you can measure and send me a couple of basic measurements of your dock, I can parameterize the model for your dock.