Clip-On Rectangular Lens Hood, for Rollei 35.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D-print-friendly clip-on rectangular lens hood inspired by vintage NKOBE 200510, for the original Rollei 35 (1960s).
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 179
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This is an original, 3D-print-friendly reinterpretation of a classic clip-on rectangular lens hood, inspired by the vintage NKOBE 200510 accessory.
The model has been redesigned specifically for modern 3D printing, with adjusted geometry and tolerances to make it easy to print, durable in use, and inexpensive to replace if lost or damaged during demanding street photography situations.
This lens hood is compatible with the original Rollei 35 cameras produced from the 1960s–1980s.
It has been tested on a Tessar-equipped camera, but should also fit Xenar-, and Triotar-equipped versions and allow the use of 24mm filters.
The Lens hood may also fit a Sonnar-equipped camera; however, it does not fit when a 30.5 mm filter is installed. Unfortunately, I do not currently have access to a Sonnar-equipped camera to verify this.
In the photos, yellow PLA is used to better illustrate fit and geometry.
For practical use, the lens hood should be printed in matte black material, or the interior painted black or covered with flocking to reduce reflections.
Print camera side up.
This is an unofficial, fan-made design and is not affiliated with or endorsed by Rollei.
❌ Not compatible with the modern Rollei 35AF (2025)