1 / 4
33cl TPU can lid and fridge magnet holder — zdjęcie 1
1 / 4

33cl TPU can lid and fridge magnet holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Ever knocked over a half-full soda and watched your keyboard take a bath? Not anymore.

This TPU lid is tested with standard 33cl cans (Pepsi, Coca-Cola, and various beer brands). While these Lids are watertight, do not expect cans to stay sealed with rough handling - no rollercoasters, or tossing them in a bag for a mountain hike. They're great for stationary garden and desk use.

  • Lids are watertight if printed in TPU (A95 shore hardness, or higher). 

  • Do not print in PLA or PETG, the lids are made with tight tolerance, attaching them with non flex filament will be difficult.

  • Calibration of TPU filament is critical. Run Pressure Advance calibration before printing - bulgy seams will prevent a tight seal. 

 Holders are with either 6x3mm or 12x3mm magnets.

Tagi