Replacement shaft for Playmobil Western Windmill
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement shaft for a broken Playmobil Western Windmill. Cut off the original, drill a hole and use an M5 screw & nut
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The shaft of an old Playmobil Western windmill was broken. I designed a replacement shaft, to make the rotor spin again. The replacement part is designed to work with an M5 hex socket screw.
Just carefully cut off the original shaft and drill a 5mm hole into the original Playmobil piece. Assembly differs from the original: You have to place the rotor first and then add the shaft and screw. Tighten it, by adding a nut and washer on the inside.
I had no issues printing it upright, without any support.
P.S: In case the rotor wobbles, the replacement shaft might be too long, depending on where you cut the original piece off. If you need a different length, either shorten it accordingly before printing, sand the print down or shoot me a message for an adjusted file. I will try to upload an adjustable version some time in the future.
P.P.S: Not sure which Playmobil model I have - might fit the model numbers 1021, 3765 and 6214. Again, feedback appreaciated.