K1 Unibody Riser - Honeycomb Storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Should be compatible with the Honeycomb Storage Wall
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 49
- Wydruki
- 2
- Wyświetlenia
- 404
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I'm hoping to find/make some tool holders and stuff for my K1. Obviously this riser is limited in which connectors you can use, since its too short for any vertically stacked pieces. Almost worth stretching the corners of the riser to fit that next row of complete cells.
I'm going to print my first set on it's back, to avoid seeing the bridging in the cells. Theoretically, it could be printed at 45degrees on it's bottom angled edge, which would all but eliminate supports, (good brim probably required)
Thanks to creators of both this Riser and the Storage Wall system!
https://www.printables.com/model/152592-honeycomb-storage-wall
https://www.printables.com/model/891616-creality-k1-k1c-unibody-riser-frame
https://www.printables.com/model/913077-creality-k1-k1c-unibody-riser-hexagon-plates