1 / 11
Mikrotik RB711 OUTDOOR ENCLOSURE with Reflector — zdjęcie 1
1 / 11

Mikrotik RB711 OUTDOOR ENCLOSURE with Reflector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I needed a bunch of these outdoor cases for a property I was turning into a big hotspot so I designed one. I usually…

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
31
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

I needed a bunch of these outdoor cases for a property I was turning into a big hotspot so I designed one. I usually use PETG for outdoor enclosures. Just hang it on the wall and cover the reflector with aluminum tape (used in duct work) to enhance coverage into whatever area of the premises you wish. There is an indoor enclosure for the RB711 also. See my "things". The OpenSCAD which produces this is included.

There is a bracket that the board mounts upon. That slides into the box and the bottom clicks into place. The box is ventilated at the top. You can glue fine screen on the inside of the box to keep out insects. Ants like to build their homes in warm places in the winter.

On that bracket are some templates which I use to make the antennas for these hotspots. That saves me doing a lot of measuring and cutting when I am installing dipoles. I make these dipoles by stripping back a pigtail, separating the center conductor from the braid and taping them to the bracket. There are templates there for 900Mhz, 2.4Ghz and 5Ghz dipoles. If your card is dual band you can put a 5gig on one port and a 2.4gig on the other. Works a TREAT!

I have included my PayPal address, "Mister can ya help a fella out?" ;)

Category: Electronics

Tagi