Filter stretcher Philips humidifier HU5710 / FY5030
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A part to stretch the filter back to normal size. My filter shrunk in size after cleaning (possibly too much).
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Suitable for Philips humidifier HU5710 / Filter part number: FY5030
A part to stretch the filter back to normal size.
My filter shrunk in size after cleaning (possibly too much).
Currently the replacement filter are out of stock, so it is necessary to clean and reuse the old ones.
After a few cleanings (or at least one strong cleaning) the filter shrinks in size and the air flow does not run through the filter anymore. The upper part with the fan has to fit onto the filters top which will fail if the filter has shrunken.
This small rod (you will need at least 5 to 6 ones) can be placed into the filters outside wall, so that the filter material is stretched again to normal size.
Some notes for printing:
I used PLA for first tests, planned to use PETG, but PLA does it very well.
The part can be printed plan on the print bed, but I preferred to be printed a few degrees twisted. I would say -3°. Please see screenshot.
Advantage: the part which has to be put into the filter is smaller and this will work better.