Latch for Fiskars 23cm (9") Brush Axe/Machete
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a direct replacement for the orange clip on the fiskars brush axe case.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
This is a direct replacement for the orange clasp on the mountable machete case. I have two versions, the "easier to open" latch can be printed in pla or whatever you like, if you are simply hanging it on the wall or using it for simple storage. It can be printed on its side, one side of the "hinge pins" is shorter to accommodate this orientation with a small triangle of support.
"2 piece fiskars 9in Brush axe Clip" was printed with PA 12 GF in two pieces, I have it mounted on my snowmobile so I needed a more robust latch that is more difficult to undo however is far more secure and robust. I flame treated the two pieces with a torch and used a plastic specific epoxy to join them. It can be printed flat on the "side" face with no support material with the "hinge pin" separate so that the layer lines remain in the ideal orientation. Once joined I annealed them for more strength, and rehydrated the nylon (research up to the individual).
I printed probably six revolutions of this model before I came up with my final design, playing around with tolerances and the required flexibility.