Test tube racks for 15mL 17x120mm conical tubes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Racks with specific horizontal spacing of columns...sorry, not sure for what, I was working off another model.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Chemistry & Biology
- Licencja
- Creative Commons — Attribution — Share Alike
A friend who works in a research lab needed some test tube racks for some conical test tubes. Designed a rack with dovetailed sides, tolerances on the dovetails are pretty close, used a nylon hammer to persuade the racks together...if loose due to different settings or filament, a drop of superglue on the flats around the dovetail should do the trick.
Plates with the 1x8, 2x8 and 3x8 in both "normal" and "loose" variants.
With the white matte PLA, noticed that a few of the holes were just a touch tight, there was a bit of an elephant's foot-like ridge at the bottom of the chamfer, a bit of sanding fixes that, but added a "loose" top for all three racks, I increased the hole diameter from 16.8 mm to 16.9 mm for those. Note: The test tubes claim to be 17x120 mm, but the diameter of the tube is actually quite a bit smaller.
If you want to modify the model in F360, there is a group in the timeline for the sides where the "feet" are made. It should be suppressed for 2 or more rows and enabled for a single row. The parameters you will most likely be interested in are num_rows, and the two *_center_to_center. NB: This was a quick model, so I took some shortcuts in my user parameters, a quick look at the sketches and rolling through the timeline should give you what you need...if not, reach out and I may be able to help.