Low Rider v1 up to 6 lines
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2-6 lines camshaft for Low Rider MMU + fysec ERB holder
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
I have not too much time for testing, so v2 came ahead me. I publish this anyway, somebody can find it usefull.
Ability to generate camshaft for 2-6 lines Low rider mmu. Line has 25mm, so add/remove length from rods as needed.
For 6 lines it is impossible to have release angle and it is very tight fit - i must fidle with cam angles in happy hare +-1 degree to not catch next gate wheel.
Do not forget to properly set selector servo in mmu_hardware.cfg, defaut values are for different servo and you will not get full 180 degree movement.
[mmu_servo selector_servo]
pin: mmu:MMU_SEL_SERVO
maximum_servo_angle: 180
minimum_pulse_width: 0.0005 #0.00070
maximum_pulse_width: 0.0025 #0.00230
ERB board holder included - you can use original board (see V2), but i have encoder, baley and EREC servo, so there not enough pins there ....
Original motor plate standoffs were too long by 2mm, and i used aliminium 80T puley instead of prined one i extended standoffs by 3mm (23mm) to use 3x30mm screws.
Currently i am testing EREC cutter with encoder, so keep finger crosed :-).