Parametrized device holder with option for usb cable insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mounted device holder with device width and thickness specified. It has a mountable usb-c connector holder
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial
A wall mounted device holder with device width and thickness specified. Thickness, holder height and back height can also be changed. Keep the wall thickness above 3mm to avoid problems.
Original intent was to design a phone holder that will charge it as well, but it can be used for other devices as well.
It has a centered mountable usb-c connector which is also parametrized (size, heigt and distance from the back of the device). It can be printed separately and then mounted. This makes it possible to print the holder upright without supports (although the corners don't print very well, because of a small flat surface)
Not that the usb-c connector should have a tight fit, otherwise you pull it up when removing the device.
I'm new to both 3D printing and 3D modelling, so feedback is very welcome!