Plate hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hang printbed plate on wall.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Goal with this print was:
slim design (2,8mm), low filament usage
use various magnets without pausing print
BOM
15g filament
1-3 x 2,5mm tapered screw
1 x 20x2 magnet (smaller can be used)
Print instructions
0,2 PETG
Clips are printed on edge, and inserted into slot. Make sure hole is somewhat clear.
I use 10mm 'tall' clips to hold a MK4 plate. If you want you can print two 7mm clips and insert together.
Note: yes, pockets for holding clips and magnet may not print perfectly. This is not an issue as not seen, or impacting strength.
Other
Personally I like to lift the plate up from the bottom, then using the wall as leverage i pull the plate towards me. Havent used more than 1 screw per hanger as they are kinda self leveling.
Printed on MK4 0,6 PETG 0,2