AC Infinity CloudPlate T5 Shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Routes heat exhaust down and out of a media rack.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 58
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This fan shroud was created to route heat exhaust from an amplifier down and out of the lower air vent in a media rack. This was better than allowing it to pool up at the top of the rack where the PC was mounted.
This is designed to adapt the AC Infinity CLOUDPLATE T5, to my particular case, but it can be adapted to other equipment and all angles can easily be changed by modifying the Parameters. It is designed in 3 sections that snap together so it can be printed even on a Prusa Mini with 180mm x 180mm print volume.
I recommend printing with a layer height of 0.20mm. Infill of 20% is sufficient, though most of these pieces print solid due to their thickness. It's really only the middle section of each piece that uses infill.
The parts can optionally be glued together, but they do hold pretty well with just compression.