Alastor Horns for Headphones
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Alastor's Horns from Hazbin Hotel remixed to fit on Headphones with Velcro Tape.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 544
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I remixed these great Alastor Horns to be used as decorations for my Headset. They can be attached to basically any pair of headphones with a bit of Velcro Tape. They pair great with these Fox Ears from @matschi. I achieved the dual color effect with fuzzy skin and adjusting the angle in the slicer so that I could do 1 color change and get both black and red on the finished print.
Print Settings
Any layer height should work with 0.4mm Nozzle
Printed in Prusament Galaxy Black PLA
Any PLA/PETG should work
Supports REQUIRED
45 degree angle to minimize supports on the finished surface and maximize strength
You shouldn't have to adjust the horn's positioning in the slicer, just duplicate the model
Installation Instructions
Thread Velcro Strip through hole at the bottom of the horns
Loop Velcro Tape around headband and cut where theres still about a 3/4in overlap for holding power
Repeat for other horn (and ears)