1 / 5
3DChameleon Mk4 Upgrade Parts for PTFE Fittings — zdjęcie 1
1 / 5

3DChameleon Mk4 Upgrade Parts for PTFE Fittings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is my upgraded design ive made for my 3DChameleon

Ocena
0 / 5
Polubienia
10
Pobrania
35
Wydruki
0
Wyświetlenia
368
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Printing Specs!
Print at .2mm layer height, 100% infill 

Here is my design of the 3Dchameleon MK4 part B and C! I've modified theses parts to be bolted together and for PTFE tubes to thread in.

( i have not printed theses parts in along time so if any issues occur please tell me! )

My current parts have over 1000 filament changes on them and i have had no need to replace them.

 

Instructions

Install parts C and B together as you normally would ( don't install any bearings or such yet )

Install M2 nuts (X5) into part ( C )
Get Small M2 Bolts (X5) and screw together part C and B ( make sure bolts don't stick out the other side )

Once they are screwed together and sitting flush, clamp B and C part in a vise gently ( or hold it by hand )

Using a tap, tap threads into the PTFE locations ( Tap the thread pitch of your PTFE fitting, its designed for M6) .. be very carful when doing this, you don't want to go to deep… go small increments and take your time. 

The fittings i used were this

https://3dprintingcanada.com/products/stainless-steel-pneumatic-push-in-fitting-pc4-m6?_pos=2&_sid=329e74e23&_ss=r

i liked these fittings a lot because it allows you to push the PTFE tube fully through and have the tube as close as possible in the 3DC having a smooth filament path.

the model is designed so you push the tube in as far as possible and will push up against it.

once the holes are tapped, disassembly the clam shells, clean all the chips out of the parts and assembly the 3DC normally! once its assembled normally, bolt the clam shells together and thread in by hand your PTFE connectors.
( they are very close together and do hit, but it still works, just take your time and go slow! )

If you have any questions or concerns please feel free to ask!

Thanks!!

Happy Printing!

Tagi