DIN Rail T-Junction for Rolohaun SimpleCore Redux
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A two-piece bracket to join DIN rails together at a T-Junction.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to use a DIN rail mounting solution similar to the Trident for my SimpleCore Redux, but was unable to span two pieces of DIN rail across and still fit all of the electronics due to the belted Z-axis assemblies underneath the deck.
I am still using the Voron extrusion mounts from the Trident for the ends of the DIN rail, but needed something for the T-Joint.
The M2 screws attach the bottom and top halves together and provide some clamping pressure on the rail. The additional M3 screws provide more pressure on the rail against the bottom half of the bracket to lock it in place.
BOM:
2 Pieces of DIN rail
(My horizontal extrusions are 400mm long, so I needed 1 x 400mm and 1 x 260mm)Qty. 3 - M2 threaded inserts
Qty. 3 - M2 x 8 SHCS
Qty. 2 - M3 x 8 SHCS
Print Settings:
Material Used: Inland (Micro Center) PETG-CF
I just followed the Voron spec for this one:
Use PETG-CF or Better
Layer height: 0.2mm
Extrusion width: 0.4mm, forced
Infill percentage: 40%
Infill type: gyroid
Wall count: 4
Solid top/bottom layers: 5
Supports: NONE