Whirlpool WHADUS5 Filter Mounting Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Printing
Print both files Whirlpool_WHADUS5_Filter_Bracket_Front.3mf and Whirlpool_WHADUS5_Filter_Bracket_Rear.3mf in a strong filament such as PETG. I would avoid PLA as it has a tendency to weaken with time and break. Print using at least 3 perimeters and a high infill such as 25% with a strong infill pattern, I used gyroid as that is my default. Otherwise I used the PrusaSlicer 0.20mm QUALITY print settings. The print files have been orientated so that they will print strong and not need supports.
Hardware
Other then the printed brackets you will need 4 mounting screws. The model is designed to use #10 flat head wood screws at least 3/4" long. I have included the FreeCAD 1.0.2 file so if needed the holes could be easily modified for other sizes. If you are familiar with FreeCAD modify Hole in the bracket_front body to any reasonable size.
Installation
To mount the brackets I used the front bracket and the water filter housing to determine the placement and then marked the top and front edge with a pencil. I then removed the water filter housing from the bracket and placed the bracket back on the wall aligned with the marks. I marked the top most mounting hole with a pencil and drilled a 1/16" pilot hole after placing the mounting bracket off to the side.
Then screw the front mounting bracket in using the top screw, leaving the screw loose. Using a small level plum the bracket and then mark the bottom screw hold. Swing the bracket out of the way and drill the pilot hole. Mount the front bracket with both screws now and tighten.
Use the filter housing to space the rear bracket, mark the side with a pencil.
Then remove the filter housing and using a small level position the rear bracket next to the marked line from before and level with the front bracket. Mount in the same manner as the front bracket.
Mounting the filter housing off the floor of the cabinet has reclaimed storage space and also neatened up the area.
The filter housing is also fully removable for easy access to filter changes or other maintenance.
