Wuben X4 tactical Belt holster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My next iteration for a new tactical flashlight belt holster for a Wuben X4
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 890
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
After using the Wuben X2 for the last 2 years I upgraded my game with a X4 model. Therefor, I upgraded my reliable tactical belt holster for it.
A snug and solid fit for your WUBEN X4 EDC flashlight on your belt. Easy and quick to access anytime you need it. Secured by a clever "snap in" mechanism.
The holder features water drain holes, so water does not collect at the bottom of the case.
The Belt mount I got from cults, and you have to buy it there:
https://cults3d.com/en/3d-model/tool/tactical-belt-clip-print-in-place
All you need for this build are some 3x M4 washers, 3x self cutting M3 screws with a length of 10mm and a Stripe of fabric tape. (not a must but a nice add-on to not scratch your X4 over time)
fabric tape:
https://www.amazon.de/-/en/51608-Fleece-Insulating-harnesses-adhesive/dp/B00PAC9OAK/ref=sr_1_5
Place the print it place belt mount from cults on the back of the case and align the top middle hole with the belt mount.
Use the washers and the screws to mount the belt mount to the flashlight holster
Placed a small square of rubber sponge on the clip mechanism in between the main holder and the belt mount (check pictures). Add a stripe of fabric tape on the front facing inner side of the case for a tight fit.