Incarna Tokens Tray shortened

Printing this insert requires a perfectly calibrated printer because the measurements have to be extremely precise. I strongly suggest to print some test pieces to check if they fit.

In my case, I had to shorten some pieces for the Spirits Box.

Elements Tokens Tray: in the slicer, I resized the short side to 99% and the long side to 96%, shortening each side by about 2 mm. Since I printed the multicolor version, I also had to reduce each element tray, scaling the long side to 96% and the short side to 99%. Be sure to measure the available space for the last tray before printing it, as you may need to use different scaling values (this advice also applies if you print the insert without this remix).

Incarna Tokens Tray: this is the model attached to this page. I shortened it by editing it in Tinkercad, removing 2 mm from both the long and short sides, without stretching the token slots.