POOL CUE HOLDER - Medium (5Cue)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATES:
July 5th 2026:
add a base model for medium size. I will also upload my small and large models here for yall to use.
so now i created a small (3 cue), medium (5 cue), and large (5 cue) models.
FEB 1ST - New profiles will be added with updates tomorrow Feb 2nd when I get back home. I added a pause at level 55 to add weights to print and have the bottom a solid smooth cover. Also, finally found some badass non slip rubber on amazon that works amazing too!
make sure you lengths are the following for weights to fit with a lil room…
x: 65
y: 135 (most important)
z: 30
.16mm High Quality @BBL A1M
Strength:
wall loops 6
Infill Density 30%
Infill Pattern Rectilinear
Quality:
Ironing Type Topmost surface (important to make it look good)
I also add new profiles with desgin updates. todady i wil add the TEXT, embedded into top of holder. So Cool! I am trying with and with supports to see if a huge quality difference in print on A1 Mini. Once i get my H2D printer alot of these issues wont be a problem.
01.3.2026
I now add it where you stop the print at level 55-56, and you can then add the weight. You can restart the print after that. This is just a preference, if you like. It makes the design look nice and locks the weights in forever. Everything is symmetrical, so it’s easier to center the lettering on your prints.
enjoy, please boost or post in comments your prints out.
PS PETG OR PLA are prefect choices. Good Luck and Play well.
Weights from Amazon:
I wanted to make a travel holder that can be customized to fit you as a pool player. I also added a cool motto on the back to help you remember to stay focused in the worst/best times during a tournament.
I made a circular and square chalk setup. If you have magnet time, you can add the magnets under the weights after the print is done. I believe they are 6x2mm holes.
Magnets from Amazon:
Here are the foam sheets from Michaels I used on the bottom to cover it:
https://www.michaels.com/product/primary-foam-sheets-value-pack-by-creatology-10104245
Glue Used:
3M Hi-Strength 90 contact Adhesive
I hope you all like the new pool cue holder. Please make sure to share remixes and setups!
-Tio