Akszon LED Skaut - ESP32-C3 SuperMini case with boot button
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
ESP32-C3 SuperMini case with boot button and device name etched on it.
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 201
- Wydruki
- 2
- Wyświetlenia
- 722
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Case for driver of Akszon LED Skaut project
This is case for ESP32-C3 SuperMini. Remixed to allow easy firmware upload (thanks to integrated BOOT button hinge). Case have clear "ESP32-C3 SuperMini" label to distinguish from other boards supported by project.
Desing was prepared for driver of Akszon LED Skaut, but obviously will work for any other ESP32-C3 SuperMini project :)
Printing
For best legibility of embossed text i recommend 0.25 mm nozzle and 0.12 mm layer height, but traditional 0.4 mm and 0.2 mm should work too. Print with PLA
Model is quite tight and need good tolerances to snap without issues. For me printing at 101% and assembling from far end, twisting-in back corners into railing and then snapping worked.